I have no spark in my yamaha banshee, and cannot figure out why.
If anyone knows about these electrical systems or knows a place that does, let me know.
This thing is really starting to piss me off.
I have no spark in my yamaha banshee, and cannot figure out why.
If anyone knows about these electrical systems or knows a place that does, let me know.
This thing is really starting to piss me off.
Start with the basics, plug, wire, wire end, etc? I replace my wire ends (that go on teh plug) every year or so since theyre cheap. I like the all rubber NGK ones. Other than that, CDI, coil, etc.
Get that damn thing running already !
Banshees are known for CDI problems I had one, But good luck.
If a hammer,crescent wrench,duct tape, or JB Weld can't fix it........Its gotta be a electrical problem
cdi, stator, coil, tors, or ground. ONLY things it can be. andy do u have a dvom to test with?
Last edited by SmokinRAM114; 10-09-2008 at 08:12 AM.
2002 dodge cummins - mechanically injected, stupid built.. never ending project
2013 Toyota Tacoma - crewcab, v6, 6 spd, 4wd, TRD package
/\/\/\ Elwrong O chris, On the banshee here the FACTORY wire harness was routed to close to the exhaust and it melted the wire and gorunded out... if you get a shop manual you can ohm out the startor and eliminate that as an issue
70 cutlass 442- dads car
95 stang- Stock long block 195,XXX miles
03 XC600 - bone stock (still faster then smokin ram)
03 Polaris predator- 4.250 bore (assembly required)
84- 4 eyed