Just had LMT install/weld my Subframe connectors and lower control arms on my Cobra. They did a great job and the price was by far the best in the area. Thanks!
Just had LMT install/weld my Subframe connectors and lower control arms on my Cobra. They did a great job and the price was by far the best in the area. Thanks!
-Tyler
Thanks! Where did you see it, at the show last weekend?
I think I'm pretty much done for now, currently keeping my eye out for a used V1 or V2 Vortech S/SI trim for a low boost setup, but that will probably come next year! Probably hit the track at least once this year while it stays N/A.
I like your setup, after seeing it in person I may have to do the COP conversion, very clean looking!
-Tyler
I stopped by the shop yesterday and they were just getting ready to install your subframes, so I took a peak! It was up in air at the time and I immediately noticed how clean it was. The car looks like its a low mile survivor!
I took my rig to the track on Thursday to see what it had in it. It surpassed my expectations! I am sold on 4V modulars!
Thank you for the compliment! I also had the power steering reservoir relocated to the shroud and the coolant overflow tank relocated under the driverside fender because I wanted to clean the front of the engine up. The 4V's look massive and I wanted to spotlight that.
Ah cool, yeah it's got relatively low mileage for the year (91,000). It's was driven so has its flaws for a 17 year old car.
If you don't mind me asking what kind of times were you running (you can pm me if you want). I'm hoping for mid to high 13s on pure street tires with a halfway decent 60.
-Tyler
They should run high 13's bone stock.
Eh...they should but rarely do, but we will see!
-Tyler
What mods?
I want a 4v sn95 in the worst way lol.
Nice times, having a lighter platform for that motor helps I'm sure too! Was the on drag radials?
My power/drivetrain mods are 4.10 gears, offroad x pipe to a flow master catback, Some unknown heavy clutch, steeda tri ax shifter and a Bama tuner.
-Tyler
Get some shorter gears for that thing too! I love my 4.10s, it could actually use some 4.30 but these work fone, no problems on the freeway, I just stay below 75 as to not murder mileage
-Tyler
I would go with 4.56's if this combo was staying n/a but, the 3.55's that I have are going to work very well for the direction I am going.
I am getting M/T's DR's mounted at LMT Friday
Nah, not while it is N/A. I've been running the Bama tunes and datalogged the car and sent them the log to dial it in a little more. Obviously not going to be as efficient as a dyno tune but good enough for me, and it gives me the SCT tuner for future dyno tuning. I would like to get a few pulls in to see how efficient the Bama tunes actually are though eventually.
-Tyler
Yeah they are stock and seem to be functioning properly (for now), no codes and I can open and close them by hand freely. I have considered zip tieing them open though and getting a new tune.
I could probably meet up thursday night this week or sometime next week at Oscar's or something like that. Send me PM we'll figure something out.
-Tyler