I'm looking for a tapered reamer bit to make the tapered hole that the shaft part of a ball joint goes into.
Looks like it should be either 7 degree/ 1.5" per foot or 10 degree/ 2" per foot. Not quite sure yet, was hoping someone might have both so I could see which one fits better.
I only have 2 holes to do, one in the top of each spindle. Right now there is the smaller 1/2" ish sized hole and I need the larger 1" ish sized hole.
For only 2 holes I can't see spending the $100 on buying the bit.
Results 1 to 4 of 4
-
06-30-2010, 06:19 PM #1Post whore
- Join Date
- Jan 2003
- Location
- Cedarburg, WI
- Posts
- 1,960
Any one have a GM ball joint hole reamer
Kevin
Daily Driver: 1999 Chevy Tahoe w/ Vortec 350
Wifes DD: 2003 VW Passat Wagon w/ 1.8T, 5 speed auto
Plow Truck: 99 Chevy K3500 Pickup w/ a Vortec 454
Toy 1: 98 BMW R1100R
87 Camaro Iroc Z28, SOLD, Gone But not Forgotten
-
07-01-2010, 08:44 AM #2Post whore
- Join Date
- Jan 2003
- Location
- Cedarburg, WI
- Posts
- 1,960
Anybody? Any of the sponsors or other shops around here that have that kind of stuff?
Looking for something like this... http://www.xkut-reamers.com/servlet/CategoriesKevin
Daily Driver: 1999 Chevy Tahoe w/ Vortec 350
Wifes DD: 2003 VW Passat Wagon w/ 1.8T, 5 speed auto
Plow Truck: 99 Chevy K3500 Pickup w/ a Vortec 454
Toy 1: 98 BMW R1100R
87 Camaro Iroc Z28, SOLD, Gone But not Forgotten
-
07-01-2010, 10:21 AM #3have pot, will stir
- Join Date
- Jun 2007
- Location
- the far west side
- Posts
- 3,061
ones at work are WAY bigger....
-Patrick
I r teh have da kewl now cuz of that ^^^^^^
"It's not a racecar if it drives to the track and goes home on a flatbed apparently"
-
07-01-2010, 01:04 PM #4Favre is my Hero!!
- Join Date
- Jan 2003
- Location
- Milwaukee, WI
- Posts
- 2,483
just buy the right kind of truck from the start?lol
Brandon
2004.5 K2500hd LLY Dmax/Allison EC/SB - Minor Mod's
2005 Trailblazer Lt 4x4 - Wife's - Stock
PS3HANDLE:SilverStreak82
Reply With Quote
2004 CHEVROLET SILVERADO 2500HD