Complete FORD and DODGE tuning now at West Bend Dyno!

**BAD LS1** · 06-28-2010, 11:59 AM

WEST BEND DYNO TUNING is now offering complete Ford and Dodge tuning for most gas-powered cars and trucks.

The method of tuning is being completed with Diablosport’s Chipmaster Revolution software in conjunction with plug-in hand Predator Hand Helds. There are also chip-burn capabilities for early EFI Ford vehicles as well like fox body Mustang’s for example.

The CMR program allows us to manipulate just about everything to make the car perform, as it should after the addition of things like forced induction or larger camshafts. We then load this built tune into the handheld so it can be chosen by the user and then loaded into the vehicle. There is no way around hand helds for OBDII vehicles at this point, much like SCT. The staff has been trained on the ins and outs of this software and many different vehicles by an ex-software developer from Diablosport who now is co-owner of ART – American Racing Technologies.

HP Tuners is available for use on any 05-09 3V Mustang as well, which spares the cost of a hand held unit for those who prefer that route. Only a one time fee of $100 is needed for credits to access the PCM. (Note will only work on a factory STOCK PCM, If SCT or DS are left in the PCM, HPT cannot write over it until flashed back to stock by the said hand held or visit to the dealer)

The pricing structure is as follows for both Ford and Dodge:

Chip Burns: (TUNE) (BLANK PROM) (TOTAL + tax)

BOLT ON - $350.00 $150.00 $500.00

CAMMED - $450.00 $150.00 $600.00

F/I - $450.00 $150.00 $600.00

F/I + CAMMED - $500.00 $150.00 $650.00

Predator Hand Held: (TUNE) (HAND HELD -1x fee) (TOTAL + tax)

BOLT ON - $350.00 $299.99 $649.99

CAMMED- $450.00 $299.99 $749.99

F/I - $450.00 $299.99 $749.99

F/I + CAMMED - $500.00 $299.99 $799.99

Please Call 262-692-9035 for further information.