gears such as 4:10s or 4:30s be to much for a nitrous car?
gears such as 4:10s or 4:30s be to much for a nitrous car?
99-ranger
88-ranger
89-spirit
I know one person running 4.10s with nitrous and it felt right, as long as you're easy on the button. Don't know about 4.30s..
2003 Mercury Marauder: 4.10s, tune, Nittos
DD: 1998 Jeep Cherokee Sport 4x4: Rust, rattle, rumble
I know someone who runs 4:10s and a 100 shot.
I guess it just depends on your motor, suspension, tires, tranny, how much nitrous you wanna spray, and if you wanna spray right off the line or not.
Support your local sanctioned tracks!!
A 4.10 gear will run 118mph at 6250rpm with a 26" tire
A 4.30 gear will run 112mph at 6250rpm with a 26" tire
A bone stock 5.0 5spd should around 110mph on a 150 shot
I would not go any higher than a 4.10, I'd personally do some 3.73s to leave room for more upgrades in the future but I guess it depends on your goals. Or you could just switch to a 27 or 28 inch tire in the future if you needed to.
I your engine can rev high enough and you've got enough traction, then no, it shouldn't be too much.
1979 Lil' Red Express -Officially the quickest "bolt-on" LRT in the country.
1989 Shelby CSX #500/500
The most powerful production Minivan, ever...
Be sure to check out my weekly adventures on the second page of your Sunday Comics!
What kind of car? Engine? MOds? Tire size? Gear ratio of trans? How can anybody know?
2001 Subaru Forester
running a 75 dry on a 26 tire DR with 4.10 thru a 5 speed. I never spray out of the whole. car makes 300 RWP 360TQ NA. I wouldn spray out of the whole. I use it when rolling in the middle of at least 2nd second, I run a 275 nitto though. The 2-3 shift comes pretty quick when its on the smack.
If a hammer,crescent wrench,duct tape, or JB Weld can't fix it........Its gotta be a electrical problem
I sprayed a 100 shot on a 4.56 gear. with a 28" tire. Out of the hole.
2001 Subaru Forester
never fear the gear run the 4.30 i wish i had them in mine
special thanks to: Marv @ C&M performance 262-993-6605
What size tire and what ratio transmission? Transbraked 3 speed or is it a manual?
I sprayed like the Orkin Man one second after launch with 4.10s and 31x10.50s stickies on a 2.48 first gear on a transbrake. If I had DRs I waited until second gear.
Buy made in the United States. Otherwise your job might be next. Unless you already wear black shoes and a visor with golden arches on it to work in which case your fellow american has already failed you.
dont do the 4.30, with the 5.0s and the ammount of spray you want, RPM will be what you want to avoid, you want the pig to hit hard stick a 28" tall tire under it, 410 gear. and that will work fine with the hit that you want to run.
70 cutlass 442- dads car
95 stang- Stock long block 195,XXX miles
03 XC600 - bone stock (still faster then smokin ram)
03 Polaris predator- 4.250 bore (assembly required)
84- 4 eyed