79 El Camino

[oneslowcamino]

Well I hate to do it but, I am going to throw the El Camino up for sale. The reason I am looking to get rid of it is I will be returning to school in a week, and I will be starting a new job with a 50% pay decrease in pay. The spindles, control arms, and core support where blasted and painted. The body is the big thing that needs to be done other than that there are just a few things. I do still have all the chrome. I also have the patch panels from Good Mark for the drivers side.



Engine

350 .020 over 4 bolt main
GM PM Rods
Ported and Polished 906 Vortec Heads
Comp Cams 268 Xtreme Energy Hydraulic Flat Tappet
Edelbrock Performer RPM Intake Manifold
Holley 1850 600 CFM Carb.
Holley 80 GPH Mechanical Fuel pump
Holley Fuel Pressure Regulater
Jegs Fuel Pressure Gauge
NOS Power Shot Nitrous System
Mechanical Nitrous Pressure Gauge
Headman Hedders
Proform HEI Distributor Tune up Kit
Jegs 8mm wires
Mr. Gasket 180 degree Thermostat
Flex-a-lite Race Fan with aluminum spacer
OE replacement radiator
New water pump

Chassis/Trans

UMI Solid Motor mounts
A/C Delete Panel
S10 Manual Steering Box
Moog Outer Tie Rods
Moog Inner Tie Rods
Moog Pitman Arm
Moog Idler Arm
TRW Upper and Lower Ball Joints
OE Replacement Tie Rod sleeves
Front Hotchkis Sport Springs
Lakewood 90/10 Front Shocks
New Brake Calipers
New Brake Pads
New Wheel Bearings
Auto Meter Ultra Lite Oil Pressure Gauge
Auto Meter Ultra Lite Water Temp Gauge
B&M Mega Shifter
B&M Shift Kit
Big End Performance 2600 Stall
2" Bolt on Fiber glass Cowl Hood

$2700

[Irish]

PM Crawlin... I know he is looking for a toy!

[oneslowcamino]

bunp

[oneslowcamino]

$2700 with the kit.

[oneslowcamino]

$2500 takes it all.

[Irish]

How much would you want for the long block?

[oneslowcamino]

PM sent . Let me know.