Small engine machine shop

[BOSS LX]

Where is the best place to have machine work done on a banshee motor? I don't know yet, but most likely just the upper end.

[Breecher_7]

What EXACTLY do you need done, odds are I may be able to take care of it at work. I thought you sold the banshee?

[BOSS LX]

What EXACTLY do you need done, odds are I may be able to take care of it at work. I thought you sold the banshee?

I bought a super clean 2002 with a melted piston. So for sure the upper end will need to be addressed.

I am not sure what I want done yet. Maybe just go through the bottom end, and possible a race upper end.

What do you think?

[Breecher_7]

I bought a super clean 2002 with a melted piston. So for sure the upper end will need to be addressed.

I am not sure what I want done yet. Maybe just go through the bottom end, and possible a race upper end.

What do you think?

I think the sky is the limit....

[BOSS LX]

I think the sky is the limit....

Yeah, I guess. I already have one way over priced motor to worry about.

Maybe just a big bore rebuild, with a cool head.

[slow90z]

http://www.trinityracing.com/ Just get a top end from them. they make their own cylinders which supposoudly people have been making close to 80hp on pump gas with stock bottom ends. When my top end finally goes out on mine thats what im looking at buying. You don't need a stroker, just get good cylinders/head and jack that compression.

[Trutildeathxxx]

call donny at aer. we can do all motors big and small. 262-521-2250

[badass88gt]

Too bad we're so far away, there is a guy up here that has an incredible reputation, specializing in Banshee's.

[BOSS LX]

Too bad we're so far away, there is a guy up here that has an incredible reputation, specializing in Banshee's.

Whats his name?

[BOSS LX]

Let me know if any of you guys have some banshee parts laying around.

[badass88gt]

John Budnick @ B&B.

http://www.b-bpowersports.com/

[wrath]

How much do stock Banshee cylinders cost these days? When I used to race my Blaster I used to buy new cylinders as it was about the same amount for a new cylinder as a bore & hone-to-fit. I just honed myself. The only problem was the 6-8 hours of porting each time.

[70 cutlass 442]

go to trinity or slp performance. they are the only ones i would even consider letting touch my banshee cyls, most the guys now are 4 storke guys and dont know much about 2 strokes.

[SmokinRAM114]

Where is the best place to have machine work done on a banshee motor? I don't know yet, but most likely just the upper end.

Williams Motowerx FOR THE FN WIN!!!!! www.williamsmotowerx.net

Jesse will set u up with what you want!