Good excuse to buy a new toy.......er tool. What did you guys use to cut the hole. I have a dremel, but it doesn't make sense to use a ton of wheels when I could just use a heavier duty tool.
Good excuse to buy a new toy.......er tool. What did you guys use to cut the hole. I have a dremel, but it doesn't make sense to use a ton of wheels when I could just use a heavier duty tool.
2011 Chevy Malibu
Just make sure you have a good cut off wheel. I used a 4" grinder with a cut off wheel but it would have been easier with a die grinder with a 3" wheel. Also be carefull not to cut deep, the lines are about an inch below the trunk/floor pan from what I remember. You need to be carefull
you have to drop the rear diff to get the tank out.....
I would cut the panel like posted, screw that dropping the rear/tank crap. I saved those instructions for a later date also.