pushrod length??

[folkswagen]

302 with D0OE(351)heads probably gonna just use stamped steal rockers, what do i do for push rods, i see that a few companies make adjustable ones to get the correct measurement but im just seeing if any one knows the answer so i don't have to **** around with a whole bunch of shit.

[badass88gt]

Nobody will know the answer, there are too many variables, heads milled, deck height, valve length, gasket thickness, etc. The proper way to do it is buy an adjustable pushrod and measure.

[DurtyKurty]

I ran stock push rods on my 302/D0OE combo.

I hope you know that the stock rockers don't just bolt on.

[DRK]

what do i do for push rods, i see that a few companies make adjustable ones to get the correct measurement but im just seeing if any one knows the answer so i don't have to **** around with a whole bunch of shit.

Post of the year,.... so far!

[folkswagen]

"DRK' you continuisly keep pissing me off on here. i ask a question on here because i dont know the answer and then you come on here acting like some smartass like you know everything. "post of the year hey?"

[folkswagen]

I ran stock push rods on my 302/D0OE combo.

I hope you know that the stock rockers don't just bolt on.

what stock pushrods? 302 or 351. what rockers did you use?

[badass88gt]

You would use a 302-ish length pushrod since you are using an 8.2 block.

[DurtyKurty]

what stock pushrods? 302 or 351. what rockers did you use?

I used a roller 302 block so I used stock roller 302 push rods. I used stock stamped steel rockers.

[DurtyKurty]

You have to pull out the old stock rocker studs and put in these threaded inserts in if you want to run stock type pedestal mount rockers.