Yeah the sound really helps to get a feel for it.
This converter is considered tight for an aftermarket "high stall converter". It drives very nice on the street!! That's the main reason I went with the Yank custom "PY3400E" model, the nice driveability. I drive my truck 99% on the street so I tried to get a balance between driveability and just enough stall to get the truck screaming off the line at the track. The higher the stall, the more top end you trade off and the "sloppier" the shifts get.
I agree with these guys that if your rear brakes are weak it could make your converter stall at an artificially low RPM. What about when you go up a steep hill? Does this converter act different than your old one? A steep hill is a great test to compare converter looseness.
Josh
91 GMC Syclone, full street trim, full accessories, stock bottom end.
11.45 @ 117.7 57mm PT51 turbo at 20 PSI, 93 octane street tune w/alcohol injection. D.I.Y. Budget build, <$4500 under the hood complete.
Well, I took it out last night. I found a steep hill out in the sticks of Mukwonago & got it going nicely up the hill and the tach managed to come slip upwards of 3000ish while not feeling as if I was getting on it. When I was on a straight-a-way going 40 in "Drive" I punched it & it "Flashed" up to 3200 & took off. I guess this is all legitimate. What gave me the first impression of my concern was when I was breakin the tires loose at 2100 w/the brakes on. But I now know that the problem there resides in the resistance it takes the car stop the tires is too weak. I appreciate all of everyone's info in trying to figure this out! See ya round. btw, thats still a kickass vid, i heard it on my comp last night. 0-60 in what, 4 seconds?
glad u got the right stuff, see you sunday?