Stuff For Sale

[loud91rs]

Ok guys, I have a baby on the way so I gotta get rid of some toys to pay off some stuff...
Focal Typhon 8" Components (210 EX)
Focal 2-way 6 1/2 (CA165)
$230 for the set?
JL Audio 10w7 in homemade box $300
Alpine (9811?) deck, no built in amp, very nice deck, plays mp3s flip down face, angle face as well $120

Motor:
Chevy 350 bored (.030) over
4 Bolt main
Pre 86 block (older motor)
Has trickflow alluminum heads(i'll get more info if interested, paperwork in my toolbox)
Elgin Cam
SRP pistons
Holley 750 Vacuum secondary carb
Edelbrock RPM Air gap intake
Polished pulleys
Supposidly bottom end and pistons are all forged, i'm gonna assume not until i pull it apart?
Compression is 10.1:1, it was said to be setup for a big shot of nitrous but never had it
Alternater, power steering pump, and water pump all included
Summit mini starter
HEI distributor
Chevrolet Black valve covers
Comes with engine stand
I'm probably missing something but oh well, just ask questions and i'll do the best to answer...motor went 12.0 with 4:11 gears and a t5 tranny in a 91 camaro. Add headers and a trans and go. I'd hate to let it go but I don't want it to sit around.
Looking for $1400 cmon guys help me out here
Bare block motor, 350 not bored over. $50?
TH350 from an 81 camaro, converter included. $50?

[Tiresmokin]

Is the TH350 a dual pattern? I need a trans for a Cadillac engine, which is the same as BOP.

[loud91rs]

All I know is that it's from an 81 camaro, any way I can find out for ya? The trans was said to work when taken out, but can't guarantee anything, so assume it needs a rebuild.

[Tiresmokin]

Hoping to have a known good trans. On the bell housing you would see extra bolt holes fairly close to the other set (within 2 inches?).

[Slow Joe]

Bump for one kick ass engine!!

[loud91rs]

Thanks Joe. $1600 takes this motor, I really need to sell it. C'mon Judge this it would be awesome in your trans am!

[Slow Joe]

Thanks Joe. $1600 takes this motor, I really need to sell it. C'mon Judge this it would be awesome in your trans am!

Anytime Fox... Oh and I told that f*cker that it'd be the perfect motor for his T/A... I even told him that I'd help him put it in The T/A would blow the doors off his GTO though, even with it fixed... Well if it's stock...

Yet another bump for an awesome motor!

[Poncho]

if I had the money.

can I still run my 88 tuned port setup on it? I thought there was some funny incompatibility w/ pre 86 engines.

[loud91rs]

From what i've read you would just have to swap intakes, but supposidly the major bolt holes stay the same for pre 86 and post 86 motors. thirdgen.org would know for sure. you would have to do a ton of work in the tpi to get it to it's potential with that motor, but i'm sure you know that.

[loud91rs]

Bump dropped price on motor