****junkvr4 Complete Part Out*****

**DSMDuDE** · 06-12-2006, 09:09 AM

Engine is currently at Apex in chicago being all checked over and assembled with: (1) new piston (1) new rod (4) new piston rings, and all new bearings

Asking $2500.00

ENGINE
Built 2.4L G4CS
- Wiesco 9:1 pistons
- Eagle Rods
- All ARP fasteners

2.0L head
- HKS 272/272 Cams
- Fresh rebuilt
- Crower Springs
- Crower Retainers
------------------------------------------------------------------------------------
Whole turbo setup just had the following done: Rebuilt by sound performance, Exh manifold Jet hot'd, 02 housing Jet Hot'd, comp housing polished
includes:

FORCED INDUCTION
-SCM61 Turbo

-Tial 40mm Ext Gate

-Ported 2G exh manifold

-122 performance 02 housing

Asking $1200.00

PICS: http://www.junkvr4.com/gallery/index...name&order=asc

--------------------------------------------------------------------------------------

INTAKE
-Spearco 2-216 FMIC - $400.00

-Tial BOV - $200.00

-FRH intake manifold w/ Mustang TB (just prefessionally polished) $450.00

-Buschur manual boost controller - $75.00

EXHAUST
-3" SS exhaust - Turbo back - Comes with Rolling chassis

FUEL
-15GA Aluminum fuel cell - $150.00

-PTE 1000cc injectors - $300.00 BRAND NEW!

-Aeromotive -10 FPR - $150.00 BRAND NEW!

-10AN Feed, -6AN Return, and fittings - $250.00 BRAND NEW!

-Aeromotive A1000 pump - $250.00

-Custom sound performance fuel rail -8an in/out $180.00 BRAND NEW!

-Aeromotive 10mic and 100mic filters - $180.00 BRAND NEW!

ELECTRONICS
-AEM EMS, AEM Wideband, AEM 3.5bar map sensor, IAT sensor - $1500.00

-autometer Boost gauge - $20.00

-autometer Coolant temp gauge - $20.00

-autometer oil pressure gauge - $20.00

DRIVETRAIN
- Good shifting Late 91 AWD trans with Welded center diff 23 spline- $400.00

-Quartermaster/Devotuning Twin disk clutch - $800.00

- 23 spline X-fer cases - $100.00 ea

RIMS AND TIRES
-19" Centerline RPM Rims W/ new tires - $1000.00

Pics can be seen @ http://forum.widsm.org/garage.php?mo..._vehicle&CID=4
AND
http://gallery.junkvr4.com
-------------------------------------------------------------------------------------
*****ALSO*****
ROLLING CHASSIS
1991 Mitsubishi Galant VR4 #21/2000 is being sold as a rolling chassis
includes:
4 bolt rear end
5 lug conversion
ABS removed
all axles
*maybe* ecu to throw in it
KYB GR2's
RR H&R Springs
FRT stock springs
(4) Laser AWD rims(charcoal) with good tires
3" turbo back Stainless Steel exhaust

***PICS***
http://www.junkvr4.com/gallery/index...name&order=asc

I need to install the gas tank, and secure all the fuel lines i was starting to remove for the fuel system, car is in good condition, little scratches here and there but nothing big, no rust

Asking $1500.00 OBO

Questions please E-mail me via dsmdude@charter.net, or PM me via BCM

Thanks
Nick Andersen

**DSMDuDE** · 06-15-2006, 08:33 AM

Bump....

Help support my evo

**jbiscuit** · 06-15-2006, 08:36 AM

WOW...no more GVR4 hey?

**DSMDuDE** · 06-15-2006, 08:40 AM

Nope...

But better will come along

**jbiscuit** · 06-15-2006, 08:42 AM

good luck on the next car!

**DSMDuDE** · 06-15-2006, 09:40 AM

Thanks!

Then i can ditch the trailblazer, and have a fun, fast, Daily driver.. oh yea.. and reliable!

**Teufelhunden** · 06-15-2006, 11:10 AM

Someone save this very clean* GVR4. It deserves a good home...

*I last saw it when WilliamZ still owned it.

**rally_scort** · 06-15-2006, 12:06 PM

u have any oil restrictors by chance...i need one for a t3/t4 or equal....

**DSMDuDE** · 06-15-2006, 05:32 PM

Originally Posted by MoparScott

Someone save this very clean* GVR4. It deserves a good home...

*I last saw it when WilliamZ still owned it.

Yes.. someone PLEASE save this chassis

comes with lots o goodies.. and 1500 is NOT firm

Thanks
Nick A.

**Flicktitty** · 06-15-2006, 09:04 PM

BUMP FOR A BAD ASS GVR4!!! Hey nick find me a stock motor and tranny for it, and put it in for me!

**Stangman98** · 06-26-2006, 03:58 PM

Lowest you can go on the A1000?

**DSMDuDE** · 06-26-2006, 04:20 PM

Sorry that is sold

Thanks,

**DSMDuDE** · 06-26-2006, 04:37 PM

Following that is left

19" Centerline RPM rims with basically NEW tires $1000.00

Whole turbo setup just had the following done: Rebuilt by sound performance, Exh manifold Jet hot'd, 02 housing Jet Hot'd, comp housing polished
includes:

FORCED INDUCTION
-SCM61 Turbo

-Tial 40mm Ext Gate

-Ported 2G exh manifold

-122 performance 02 housing

Asking $1200.00

PICS: http://www.junkvr4.com/gallery/index...name&order=asc

Thanks

Thread: junkvr4 Complete Part Out*

Thread Tools

Display