Gotcha, Thanks i'll be sure to try that out.
Type: Posts; User: Flicktitty; Keyword(s):
Gotcha, Thanks i'll be sure to try that out.
yeah the ECM Temp sensor and the Gauge sensor are pretty close in reading (within 5 degrees typically) Had an issue when i replaced the alternator something with the electric fans broke so i had to...
Thaks, I'm in the Menomonee Falls,Brookfield boarder off Pilgrim and Silver Spring area.
I will have to look into the o2 setup and double check the wiring from the wideband to the ecu.
As...
hmm that might be a bit of a stretch to pussy foot the car down there, i'll see what i can do, otherwise i'm more than willing to compensate your time/travel.
Correct me if i'm wrong, but say...
Wideband is new (as in like 15 minutes of run time as of now) The Car with the new and old sensor ran the same way.
Starts and runs at 14.5-14.9 then it riches up to
11.4 - 11.6 @ 115F (water...
Thanks Murray.I've checked a few other things, replaced and tested stuff, car seems to run ok now, Just starts and runs around 14.7ish then dips way down into the low-mid 10's once the car gets...
No leaks from the intake manifold
Vac is usually in the 18-20 Range, when the car starts to miss it starts to lower the rpm and thus lowering the vac. The place that wired the harness up...
I haven't done one yet, i will try that on thursday.
Don't believe so. Only have a few vacuum lines
Wastegate-Turbo Which is fine.
Turbo to intake manifold - Which is fine as well.
FPR to intake manifold - Which is newly replaced and tight
Blow...
The Car: 1989 Nissan 240sx - Aristo 2JZ-GTE - AEM EMS V2 - Single turbo kit setup - FIC 750cc injectors and Rail - Aeromotive FPR - Deatschwerks DW300 fuel pump - Russell fuel filter.
Part...
Does that mean that the rules are any less strict? i remember how many more rules the track had to abide by when it went NHRA
Last i heard AMS was $150/HR to tune. not sure how accurate that is.
The issue is where you live, There is a decent car scene in the Fox Valley area
i'd check with Murray (WhatsaDSM) on here he tunes sometimes at West Bend Dyno he could be of some help.
Sounds like a pretty cool setup, What do you need tuned though, The engine setup looks pretty stock imo short of an intake, and an intercooler upgrade i dont see much else.
Also if you can make...
best bet on photos is to make an account on a site like photobucket.com and do it that way, or you can usaully link them from facebook.
I didn't mean to come off saying you didn't have it, i just...
I don't think AMS will touch is, I know they are turning away EVOs,DSMs,SRTs,etc So i can't see them doing this. So i would have to say X2 on Sound Performance, only thing is if you actually did do...
Nice truck in too for results.
I must say, i have a huge soft spot for the 2011 + 5.0 Mustangs. Whats done to the car as it sits now?
on paper yes, he should be able to get around him, but this isn't a door to door road racing event. You have to get waved by (the driver has to point the rear car by) If you had a ZL1 Camaro would...
I think what Murray is saying is if the Camaro is ONLY faster from T14 to T1 and T3 to T5 There is ALOT of ground that the slower car will go around him, But in track day's like this you have to...
good score. Always liked those things.
Not a problem, Gino does some great hydrodipping work. Just about the only local place (Not in Chicago) that does it.
Gino @ Team Gilleto in Butler, Tell him Nick & Liz sent you.
https://www.facebook.com/TeamGileto?fref=ts
That's awesome Ron. Might have some ideas floating around.
this is gonna be pretty cool, looking forward to it.