Since gas prices are on the rise, im thinking about picking up a project sportbike to tinker with.Is there any local places or websites that cater to people looking for rebuilder bikes?
Type: Posts; User: rally_scort; Keyword(s):
Since gas prices are on the rise, im thinking about picking up a project sportbike to tinker with.Is there any local places or websites that cater to people looking for rebuilder bikes?
i got the cam with the heads, but it is used and the lifters weren't numbered.Im thinking of going with a new cam and lifter set, since flat tappet stuff is dirt cheap.Id like to move my powerband up...
My 94 Silverado will be going under the knife this weekend.The trans is falling apart, and the motor is less than stellar in the performance department.Ive been gathering parts, while maintaining the...
I read about 2345625 more threads about TBI troubleshooting and found a major issue.The MAP sensor needs to be fed off the rear fitting on the TBI, mine was routed to the front.I swapped it with my...
its throwing codes 33(MAP sensor) and 43(Knock sensor)...im going to check over the wiring and make sure both sensors are plugged in and trace the wiring back to the ECM.Im leaning towards the knock...
I pulled the ECM out, and looked up the Service number on the sticker.It says here http://tbichips.com/ecminfo.htm. The service number on the case is listed as being used in 94-95 light duty...
I researched the service number on my ECM and its supposedly the correct computer for the truck.The service number is 16197427.Its listed as being used in 94-95 light duty trucks and some heavy duty...
im assuming the computer is behind the glove box?
im all ears, ill check up on the PROM number tomorrow and work from there...im starting to think this truck might have a baby cam, causing the MAP to freak out.If i cant figure it out somewhat soon,...
i appreciate the info.Was i on the right track, being able to set base timing by jumping the A and B pins?
94 Silverado with 4.3TBI-5.7TBI swap and a 4L60
Short version.....Am I able to set my base timing by jumping the A and B terminals in the diagnostic port?
Longer version.....I picked this truck...
Did the misfire dissapear after the new cap/rotor? If it went away for a bit, check the cap again for corrosion.If its the stock-style disty, it could be your problem.We have had many come in with a...
true, all 4 wheels will have a speed sensor, but it wouldnt make much sense to have the TC sensor read off the rear wheels.It would throw the whole system in a frenzy if you pulled the ebrake and...
My 73 Malibu is sitting on 3 different style steelies right now, so its time to find some wheels.Ive searched around and i cant seem to find a set of wheels that looks right on the car.Its obviously...
yes and no.Most newer GM's do have servicable sensors, but they are made of plastic and corrode over time and wont come out without snapping off.
As for the which wheelbearing is out, IIRC the...
9 out of 10 times, your already hearing a grinding noise especially while turning.If you cant determine which side is making the noise, jack the front up and check the wheel bearings for play.Grab...
diagnose which side needs a wheel bearing and replace it.
thats exactly what i was talking about.It looks like an EGR, and is located where an EGR valve would normally be.Ill have to smell it and see if it smells like an EGR :rolf
what do they call the EGR-looking solonoid that bolts to the head? I was under the impression that a secondary air-injection system would be another name for EGR on these vechicles.
Its an emmision related air pump.I'm only aware of them installed in the Trailblazers, Rainers, and Envoys.They are located on the frame rail under the drivers door.It has two hoses(one heads to the...
we've installed a few recently, a rebuilt cluster costs us about $300 and not much labor involved.The other more prevalant problem that should be address is the secondary air injection setup.It was a...
Hotchkis was the first place i looked, i didnt see any lowering stuff.They do offer some little suspension goodies, but coils werent shown on the site.
I picked up a 73 malibu for a summer cruiser.I want to lower it a few inches, and run a 17" or 18" rim.What options do i have? I know in some cases, its possible to use coils from another GM car, but...
My 90 ranger has a 7.5" rear with an open 4.10 carrier.Im picking up a svo rearend today, with 3.42s and a posi.In a perfect world, id like to grab the shims with the svo carrier, and plop it in my...
flush the core.Mine was the same way after i did my pump.Also, let it run for at least 20 minutes with a funnel on the radiator.My truck, which is identical drivetrain as yours, took a looong time to...