Hey I figured we should have an import dyno page stating whp just for fun and we can rank Milwaukee's highest hp imports. If you have never had a dyno just give a number people with your same setup has achieved.
I'll Start
1992 240sx
315whp
Printable View
Hey I figured we should have an import dyno page stating whp just for fun and we can rank Milwaukee's highest hp imports. If you have never had a dyno just give a number people with your same setup has achieved.
I'll Start
1992 240sx
315whp
ok here is the first:
2.2L DOHC Vtec
Beeyond Engineering Turbo kit(GT35R turbo)
23psi(low boost)
PEAK POWER OUTPUT = 617whp
PEAK TORQUE OUTPUT = 481ft-lb
I'll post dyno sheet later :thumbsup
i wasn't able to put it on the dyno sadly enough, i had a 60-1 @ 32psi, turbo maxes out at 575whp @ 32psi:DQuote:
Originally Posted by boostaddict14
can't you dopes just LEAVE A DAMN THREAD ALONE! have some courtesy. Put your domestic/import/shitpile/uubercompact/microcompact/.5 cylinder numbers in here. don't post crap either. Bee showed dyno results before, and from what i remember, he DID make that. if ANY of you can't just post results, IF you even have them, then DONT POST.
if you don't understand, look below. Dave made a proper contribution to this thread.
270hp
220tq
Sooo.... Did you ever make this number anywhere but in theory?Quote:
Originally Posted by spindler27
Eitherway...
Superflo dyno using DynoJet correction factor.
828fwhp
596fwtrq ( on the small turbo @ 41psi ):D
http://jhracing.net/images/dyno_graoh.jpg
I have a 22psi GT35R slip somewhere I can dig up too. That one was 530fwhp.
Jake H
02 silver neon.... all bolt-ons, no cam, no internals(stock long block) no tune(stock PCM) no spray
127whp
135wtq
never got to put it to the rollers on the squeeze....
i wasn't going to post a thing, but the OP said post similar numbers, same turbo, same mods, same boost, and they made 550+Quote:
Originally Posted by TopStreetDsm
WOOT WOOT for the saturn ........ and thats through a stock exhaust!
http://i22.photobucket.com/albums/b3...tydynorun1.jpg
1986 Honda Elite 150, liquid cooled normaly aspirated:
http://www3.telus.net/dougsimpson/Carbmm.JPG
11HP (eleven) peak, torque....off the chart.
'94 Supra @17psi (just bolt-ons)
424whp/423wtq
Not going to break any records, but I like it. :)
http://www.fquick.com/images/vehicle...jpg?1207319186
Saab 9000, 90 degrees outside, just exhaust...
http://i195.photobucket.com/albums/z...n/scan0002.jpg
Saabs are slow.... :confused
'82 12a powered rx7
120hp-140hp ish at most
Holley Carb, RB intake, slight port, RB Header, full exhaust
11/3/2007 - Beyond Redline Performance on a DynoCom AWD dyno
SAE Uncorrected #'s:
2.3L with GT4088R
740AWHP at 6000rpms
696Tq at 5200rpms
Full boost at 5100rpms
Over 700AWHP from 5000rpms to 7600rpms
Over 600TQ from 4500rpms to 6200rpms.
Just re-dyno'd on Luke's new DynoJet AWD dyno within 0.6% (735.6AWHP), SAE Uncorrected #'s.
New numbers to come shortly.
http://www.brewcitymuscle.com/forum/...6&d=1207600244
nice tim.... :thumbsup
put that hp on the ground and you'll be deep deep into the 9's :thumbsup
Trying to get the corolla RWD 4g63 engine to do 700-750whp. Getting the GT42r soon so we'll just have to see. May spray to get it moving since we are still 2.0L ;)
see you around
Supercharged Honda S2000
Not dynoed yet, but rated at 340 Crank hp (170 hp per litre :P), without any type of intercooler. I i have a FMIC. So my guess is 350crank, 280ish whp.
Common Bee! When is the dyno day? :goof