Custom cat back on my bimmer

Stock one broke right after the cat after the welds brroke (last time it was replaced they elected to weld a stock on in vs unbolting the thing and putting it back in normally.. dont ask me why)

I elected to just have new stainless pipes ran from the cat to the stock muffler eliminating resonators. BMW stock mufflers flow great from the factory and aftermarket ones have a marginal impact on performance other than sound *if* you are lucky. I've had aftermarket mufflers on before and all it does it attract attention.

So in this case we just elimated the resonators and saved a bunch of weight. It actually sounds perfect imo especially under load flying under bridges and tunnels.

Ron did an excellent job and by far the best quality work that I have seen before on any exhaust project.

http://farm9.staticflickr.com/8027/7...e3f88200_c.jpg
http://farm8.staticflickr.com/7252/7...324d2ec5_c.jpg
http://farm9.staticflickr.com/8005/7...95cc9d4b_c.jpg
http://farm6.staticflickr.com/5112/7...d3d7bb6b_c.jpg
http://farm6.staticflickr.com/5322/7...92d8ba30_c.jpg

glad we could take care of it for you.
Thanks!

w00t for stainless! Do it once and be done!

Looks good! Ron, eventually I will be bringing my Lexus down for some custom mid-pipe work :)

That looks great! Nice job Ron!

Once my car is painted next winter I need a set of true duals made for.the TA as well. Looks sick

Sent from my SCH-I500 using Tapatalk 2

You should get a wolf painted on your hood Josepy. I've never seen that done before and I bet it would look great. :rolf

Quote:

---

Originally Posted by jbiscuit

you should get a wolf painted on your hood josepy. I've never seen that done before and i bet it would look great. :rolf

---

lmfao