Dual 3" stainless mandrel bent exhaust by Clocks Off Racecars
Big thanks to Ron for busting out a fully custom exhaust system for my RX-7.
-Dual 3" all the way back
-16 gauge (.065) 304 Stainless Steel mandrel bent tubing
-Stainless V-band flanges at headers and at "catback"
-Magnaflow X-pipe mid-muffer
-Dual Magnaflow rear mufflers
-fully TIG welded
Magnaflow 5in.x8in. (Part #12469) is a Tru-X Perforated Core, despite what Magnaflows website says, so it served as my X-Pipe.
https://lh3.googleusercontent.com/--...0/IMG_1417.JPG
https://lh3.googleusercontent.com/--...0/IMG_1397.JPG
Had to offset the V-Band clamps so you could get them on side by side
https://lh5.googleusercontent.com/-0...0/IMG_1374.JPG
https://lh5.googleusercontent.com/-y...0/IMG_1421.JPG
https://lh3.googleusercontent.com/-5...-46-18_621.jpg
Where we left off Friday night. (Finished up Monday)
https://lh4.googleusercontent.com/-C...0/IMG_1432.JPG
Still need to hang these two mufflers and figure out tail pipes.
https://lh4.googleusercontent.com/-u...0/IMG_1364.JPG
Sound clip of just the mid-muffler. Engine is still un-tuned, so I can't rev it much past 2000 RPM... if that.
http://www.youtube.com/watch?v=1d04pL1ssK0#ws
Car idles real funny now with full exhaust. I'm scheduled for a dyno tune next week. I won't bother with an exhaust sound clip of the full exhaust till it's tuned. I cant really rev it right now. :(
https://lh3.googleusercontent.com/--...0/IMG_1458.JPG
https://lh4.googleusercontent.com/-d...0/IMG_1460.JPG
https://lh4.googleusercontent.com/-e...0/IMG_1457.JPG
https://lh4.googleusercontent.com/-Z...0/IMG_1471.JPG
https://lh6.googleusercontent.com/-6...0/IMG_1456.JPG
https://lh5.googleusercontent.com/-P...0/IMG_1459.JPG
Hanger: stainless bracket to a rubber biscuit.
https://lh3.googleusercontent.com/-7...0/IMG_1469.JPG