What have you guys been working on? :thumbsup
Printable View
What have you guys been working on? :thumbsup
Nothing. I have a 60 degree rule in the spring, below which I don't wrench. When fall comes along, it's normally a 54 degree rule. What I need is to get a new house with at least a well insulated, preferably heated garage. As it sits, the current one is too small and too drafty to get any real work or heat done in the actual garage. All my work has taken place just outside in the driveway.
It's never been too hot to wrench though.
I hear that!
84 k30, 81 c30 and 93 s-blazer......two engines to drop in and one tranny :D so far soo good :thumbsup
I will be working on the EL Camino this winter. Got to love the propane heater!
I put my Cutlass into storage Halloween weekend and probably won't go get it til sometime in April. Hopefully by then, I'll have a TH350 built and ready to toss in. Aside from that, no plans for the car next year, especially with a wedding in June.
I know im not a "old school muscle" but Ill be doing another hid projector retro for someone and a tune up on the whip
I might change my caprice's thermostat. Completely outside though :(
still putting some extras on the 63 SUPER STOCK....then after world of wheels...putting in a new blown big block in the 69 chevelle at the shop....
Re-register, ditch smog crap, headers, gears, shift kit, tune-up, rear brakes.....might be missing something
yup my car is getting new full quarters put on. the old ones are bondo city and they were never correctly half seethed.:( i will post up pics of the progress.
I think some time in the next few weeks I'm going to swing over by tom at OTE. My Buick has been over there for a long time:crying Already paid for my cage just need to go put my doors on and interior back in so Tom can bend the cage. Otherwise than that its a new paint job this winter, bigger snail, injectors, and installing the loads of crap I have compiled over the last year when she was down cause funds ran out :fire
just getting ready to install a new engine this weekend...
http://www.youtube.com/watch?v=jn7iTcjUmTo
why such small turbos? Pump gas motor? :rolf
well 2100hp isn't bad to start with but in a 5700lb barge it should go 11.40's :)