BAD LS1
Ol' School

Hi Tom,
Looking for help tuning an OBDII Lt1 heard your the guy to talk to.

Hi Tom,
my 2000 F-body Clutch, not fully releasing .

Why would my Clutch not release fully,
even with the pedal to the floor.

the Clutch still does not completely Grab until the pedal is almost all the way out.

But even with the pedal to the floor, there is still a small Drag on the clutch and tranny, that i can not get it into first gear at a stop.

HELP?

did my Clutch Plate Swell up from when I bled my Clutch-Slave a few weeks ago? and got Dot-3 Brake fluid on my clucth disk?
or
did my Pressure plate give up?

hey Tom, hows it goin?

Ey remember when you cranked my trans psi to max--yeeeah I need you to change it back --I have broke 4 pumps and a converter hub on the last one.Rossler told me its because of too much line psi on the pump rotor this is before I told them it was cranked up--their first words were too much line psi -I broke 4 rotors a pump slider and the last one fractured my converter hub right where it drives the pump on both sides this is costing me a fortune--they claim the zpak 3-4 clutch pack automaticly will increase it under WOT 3-4 because it has a x-tra plate.Now that I know what it is,I gotta get it fixed--The car is ready again I just am afraid to drive it because it will break the rotor in 2 weeks of driving it this way.Its like friggen clock work --Get back to me 262-305-7149

The Turd Has Been Flushed! Cheers!